OpenVPN Server Configuration

Follow

Comments

5 comments

  • Avatar
    Chris Binder

    Is it possible to edit the openVPN server config file on the firewalla?  The way the automatic openVPN is setup by default on the gold doesn't allow the connected clients access to any of the devices on the remote LAN and so things like file and printer sharing are unusable. The server just acts like a privacy vpn for browsing the web.

    0
    Comment actions Permalink
  • Avatar
    Paul Smedley

    I'd also like  to know this. It's  weird - if I connect from my phone to the firewalla,  I can connect to all clients attached the the firewalla.

    If I connect from my Asus router to the firewalla, I can't connect to ANY clients attached to the firewall - even from an ssh session on the router.

    0
    Comment actions Permalink
  • Avatar
    Radagast82

    I got problems setting up openvpn server on a gold firewalla in router mode. I enabled upnp, then setup openvpn server and it says that i have to manually open the port, which is weird 'cause i expect upnp on the same very device do its job. But it's ok, i try manually open the port, so i go in the nat section, try to manually open the port but of course i can't select the target device, 'cause it's the firewalla itself... Any advice?

    0
    Comment actions Permalink
  • Avatar
    Firewalla

    @radagast82, if you are running a gold in router mode, and it is your primary router, you do not need UPnP ... If the Gold is your only router (you don't have double NAT), then check this https://help.firewalla.com/hc/en-us/articles/360055686674-How-to-see-if-you-have-a-public-IP-address-

     

    0
    Comment actions Permalink
  • Avatar
    Radagast82

    You're right, my new isp provides public ip on demand, I just asked them for one... I thought it was by default

    0
    Comment actions Permalink

Please sign in to leave a comment.