Star link Bridge mode to Firewalla and Unify

Follow

mjmcd771

• September 12, 2025 09:22

Initially starlink was in bypass mode to my UCG Max then my bridge to Firewalla. Decided to remove my UCG and make Firewalla the route. Starlink still bypass but could not,.so many times setup as a router. Would timeout after a while and dump me to manual setup. I reset my firewall as new also...reset the starlink . Bluetooth. And location on. Still won't connect. Any help appreciated must of cycled so many times, same issue . Reverted back to bridge mode as partner was sick of the net being down. Any gurus here ?

0

• 

  Firewalla

  • September 12, 2025 16:13

  The proper sequence should be

  Star-link -> Firewalla in router mode -> Unify switch/AP

  When you are installing the firewalla in router mode, make sure you reboot the starlink (or check and make sure the starlink doesn't remember the previous UCG). Also make sure there is nothing else connected to the starlink in bridge mode, otherwise, it may not work 

  0

  Comment actions Permalink
• 

  mjmcd771

  • September 12, 2025 21:02

  Right I did all that maybe leave longer to clear out any addresses. And try again....

  0

  Comment actions Permalink
• 

  mjmcd771

  • September 12, 2025 21:44

  Last thing, i was opting to use a Mac to connect to Unify devices. I downloaded the unify software. Assume I just add the Mac device and set rules to see ?

  0

  Comment actions Permalink
• 

  Firewalla

  • September 12, 2025 23:01

  Sorry I have no idea about Unify and MAC devices

  0

  Comment actions Permalink
• 

  mjmcd771

  • September 12, 2025 23:03

  All good I don't have docker skills either hence looking at options

  0

  Comment actions Permalink

Please sign in to leave a comment.