Can’t see all network devices

I can’t wrap my head around this.. Setup: Verizon FiOS ONT —-Firewalla Gold(FG)—FiOS Router(FR). I’m using the FG as my router, the FR is setup in bridge mode.. For some reason, the FG can only see the one FiOS router IP for all devices on that network. So for instance if I want to block one of my kids from a specific game site, I can’t see his IP to creat a specific rule. I can only see traffic from the router he’s on like an alert that says: G3100 (FiOSRouter) is visiting a Gaming Site, vs device name with IP 192.168.4.5 is visiting... I’ve disabled routing on the FR, disabled the firewall on the FR, rebooted.. I think the Verizon router is doing some NAT, but I can’t find where to turn it off. The FR is distributing IP’s 192.168.41.xx/24 but the only IP that shows on the LAN is the IP of the FiOS router... I have the Firewalla Gold, and the Verizon G3100 router

R Wilson

March 28, 2021 02:57

I figured it out.. thanks for the (no) help..

venkatesh c

April 28, 2021 02:32

I have the same problem, how did you resolve this ? Appreciate your help.

April 28, 2021 02:55

Do you have a Verizon router? I’m assuming this will work with most all managed switch/router configurations. 1) Go into your router config and disable DHCP and routing. 2) On the Firewalla, assign an IP to the interface/port you want to use for a network eg 192.168.2.1, 10.125.10.1..etc (you’ll need to assign an IP for each port/network you want to use. 3) connect your Verizon/Own router WAN port to the desired configured port on the Firewalla 4) done.. *** Optionally if you have a Verizon router, you will need to give it an IP address. On the broadband connection interface, give the router an IP. For some reason, my other router switch combos dint need IPs but my Verizon one did...

Can’t see all network devices

Comments

Didn't find what you were looking for?