Second WAN config

I have a Firewalla Gold in router mode, the dedicated WAN port connected to my ISPs modem and LAN port connected to my Cisco Switch. Switch connected to Cisco APs. All working fine.

Now, I have a teltonika rut950 that I'd like to set as either a failover wan2 or load balanced wan2. The rut950 is working out of the box with a sim card (i.e. I can connect to it via my phone over wifi and connectivity to the internet works). However I have no idea how to configure it as a wan2 in the firewalla app (static IP, dchp, pppoe?) And likewise what to do in the rut950 admin portal to mirror those settings.

I'm looking for a simple setup as the rut950 will be used for failover primarily, load balanced setting to actively test the config.

Firewalla

December 23, 2022 16:56

I see in the ru950 picture, it has 4 ethernet ports. And it does look like you can connect firewalla port to that and use it as a WAN. Very likely to be DHCP.

Alec Sutherland

December 23, 2022 21:11

Thanks for your reply. If my two wan sources to my firewalla are fibre optic (pppoe) and 4g (tbc) then wouldn't dhcp be handled by the firewalla? Leaving static ip or pppoe for the rut950?

December 24, 2022 00:12

That I am not sure. Depends on how your rut950 is setup. If it is a bridge, then firewalla need to run pppoe (or any protocol needed by that modem). If it is a router, then firewalla will just DHCP or static IP

Second WAN config

Comments

Didn't find what you were looking for?